Casio Electric Heater HR-212 Manuel D’Utilisation

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Unpack your heater and remove the two feet assemblies from the package.   Refer to 
Fig. 1 below: 

1.  Make sure the heater is unplugged and in 

the ”OFF” position. 

2.  TURN THE HEATER UPSIDE DOWN. 

3.  Make sure the tall part of the foot is set 

towards the front part of the heater 

according to the direction shown.  

4.  Insert the tabs on top of each foot into the 

holes at the bottom of the cabinet and slide 
forward.  ENSURE THAT EACH FOOT IS 
SECURED FIRMLY IN PLACE. 

5.  Turn the heater upright. 

 
Your heater is now ready for use. 

 
CAUTION:  Risk of fire – Do not operate heater without feet attached.  Operate heater in 

upright position only (feet on bottom, controls on top).  Any other position could create a 
hazardous situation.  

This heater is for use on 120V volts. The cord has a plug as shown at A in the following 

Figure. An adapter as shown at C is available for connecting three-blade grounding-type  
plugs to two-slot receptacles. The green grounding lug extending from the adapter must 

be connected to a permanent ground such as a properly grounded outlet box. The 
adapter should not be used if a three-slot grounded receptacle is available. 

tabs

(C) 

(D) 

Adapte
r 

Metal Screw 

Cover Of 
Grounded outlet 
Box 

Grounding 

Means 

Grounding 

Pin 

(A) 

(B) 

 
 

 
 

 
 
 

 
 

 
 

 
 

 
 

 
 

 
 

 
 

 

• 

Place the heater on a firm level surface free from obstructions, and at least 3 
ft. away from any wall and any other objects such as furniture, curtains, plants 

or combustible material. 

• 

With the Power and Setting Control “A” in the ”OFF” position, plug the heater 

into a grounded 120V outlet. 

• 

Turn the heater ”ON” by turning the Power and Setting Control “A” clockwise 
to your desired power setting (LOW or HIGH).  The Power Indicator Light “C” 

will illuminate.  

• 

Turn the Thermostat Control “B” to your desired setting from “MIN” to 
“MAX”.   

 

Setting for Optimum Comfort:  When the room reaches a comfortable temperature, 

slowly turn the Thermostat Control “B” counter-clockwise until the heater turns off.  
This is the point at which the thermostat setting equals the room temperature.  At this 

setting, the thermostat will automatically turn the heater on and off to maintain this 
selected temperature. 

CAUTION:  This heater includes a Thermal Cut-Off Overheat Protection System that 

shuts the unit off if it overheats due to abnormal conditions.  If this occurs, the Overheat 
Safety Light “D” will turn on.  Turn the heater ”OFF”, unplug it, and inspect and remove 

any objects on or adjacent to the heater.  Allow it to cool for a few minutes, plug it back 
in, and resume normal operation.  

Feet 

Carry Handle 
(behind unit) 

               Power and Setting Control                     Power Indicator Light 

               Thermostat Control 

                   Overheat Safety Light