Audiovox SCO1 Manuel Du Propriétaire

3

Two Carbon Fiber Heater Pads 
Wire Harness with In-Line Fuse
Round Switch with LED Indicator
8 Large Wire Ties

1.   Seat heater system will NOT work on seats manufactured using the “foam in 

place” (trim cover glued to foam pad) method of trim cover attachment.

2.   If the vehicle is equipped with an anti-theft radio, the radio code must be 

written down prior to disconnecting battery cable.  The code must be re-

entered when the negative battery cable is re-installed.

3.   If vehicle is equipped with an air bag, it is advisable to disconnect negative 

battery cable for 3 minutes prior to beginning installation.

4.   Only use parts and components supplied in kit for the seat heater installation. 

The supplied components are carefully selected for optimal performance. 

Foreign parts may lead to problems which could result in potential damage to 

the seat heater components or vehicle.

6.   Seats in vehicles with pre-loaded (power charge equipped) safety belts 

must be removed and re-installed under strict adherence to the vehicle 

manufacturers instructions.

7.   In cases where a seat is equipped with an occupant pressure sensor for air 

bag deployment; please refer to the manufacturer’s manual for any specific 

instruction with regard to installing seat heater kits.

8.   After installing seat heater wire harness, care must be taken to ensure all seat 

motions are still possible without obstruction and the moving of the seat does 

not cause any interference that could damage the seat heater wire harness.

9.   Installation of a seat heater system with seats containing seam lines running 

front to rear (length wise) is not permitted.  Only exception is if the heating 

pads are not directly located over the groove/s.

10.   The overall side to side (width) of the heating pads must not be altered