Bosch MUM6N10UC Manuel Du Propriétaire

Page de 88
22
Care and Cleaning of 
Blender
All components of the blender, except the 
blade/base assembly, are dishwasher safe. 
It is recommended that the blade/base 
assembly be cleaned only under flowing 
water rather than in the dishwasher. Soap 
and detergent will tend to wash out the 
bearing lubricant of the blade/base 
assembly. Do not use scouring cleaners on 
any of the blender parts.
Wash the blade/base assembly under 
running water. Do not place the blade/base 
assembly in the dishwasher or allow it to 
stand in water. This will tend to wash out the 
lubricant. After cleaning, rinse thoroughly 
and dry before using.
The power unit of the kitchen machine 
should be cleaned with a clean, damp cloth 
only. Never use coarse or caustic cleaning 
products to clean this appliance. Never 
immerse the power unit in water.
Example of Use of Blender
To familiarize you with the operation of the 
blender, a sample recipe for mayonnaise is 
provided below:
Mayonnaise Recipe
1 whole egg
1
/
3
 cup of vegetable oil
2 tablespoons lemon juice or light vinegar
1 teaspoon sugar
1
/
2
 teaspoon dry mustard 
1
/
2
 teaspoon of salt 
2
/
3
 cup of vegetable oil
Mix all ingredients, except final 
2
/
3
 cup of oil, 
for a few seconds at speed 1, then quickly 
pour the oil in through the opening in the 
cover in a uniformly thick stream, as shown 
in figure 14b. Operate the blender at speeds 
1 or 4 until mixture is thick and smooth 
(approximately 10–20 seconds).
Makes 1
1
/
4
 cups.
Tips
The blender should be operated with careful 
consideration as to what is required and/or 
desired. The speed at which the blender is 
operated and the length of operation for a 
given job will depend upon the degree of 
fineness desired or the amount being 
blended.
When the blender is being used on dry 
materials, such as nuts or dry bread, 
the best results will be obtained when the 
blender jar is filled with approximately 
1
/
2
 cup of material to be blended.
If the blender does not start (even after 
trying the highest speed) and it is humming 
or not functioning at all, the blade has 
become blocked by the contents. Try to 
switch to the “M” position to unlock the 
blades. If this does not unlock the blades 
refer to troubleshooting section.