Woodstock d4327/d4328 Manuel D’Utilisation

Your new Model D4327/D4328 Quick Release Wood Vise 

(

Figure 1) is designed to fit on workbenches 2

1

⁄

4

" and 

thicker, but can be adapted to workbenches down to 1

1

⁄

2

" 

thick by using a shim. Holes are pre-drilled in the jaw 

faces to attach aftermarket or shop-built wood clamping 

vise jaw pads.

•  Jaw Width .................................................7"

•  Mounting Height (Workbench Thickness) ..........2

1

⁄

4

"

•  Maximum Jaw Opening ..................................8"

• Weight ................................................21 lbs.

•  Jaw Width .................................................9"

•  Mounting Height (Workbench Thickness) ..........2

1

⁄

4

"

•  Maximum Jaw Opening ................................ 10"

• Weight ................................................25 lbs.

1.  Have another person hold the vise up against the 

workbench in the desired mounting location. If the 

workbench has holes for bench dogs, make sure the 

bench dog on the vise is aligned with those holes.

 

Note: If the workbench is less than 2

2.  Pencil mark the workbench through the mounting 

holes to establish locations to drill pilot holes.

3.  Use a 

1

⁄

8

" drill bit to drill pilot holes approximately 

1

1

⁄

2

" deep in the face of the workbench, where the 

wood screws will be used (see 

Figure 3).

Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz

Figure 3. Mounting hole locations.

Mounting Holes 

for Wood 

Screws

Mounting 

Holes for Lag 

Screws

Vise

Workbench

Shim

Figure 2. Shim placed between workbench 

and vise for workbenches under 2

1

⁄

4

".

Figure 1. Quick release wood vise.