Magnadyne Dual VPA Socket and USB Port Adapter DVU-2 Fascicule

The DVU-2 is a Dual VPA Socket and USB Port Adapter. This unit can be mounted in two ways:

Screw Mount and Velcro

®

Mount. Choose a mounting location that provides easy access and LED

is clearly visible. Follow the diagrams below for proper installation. 

DVU-2-INS  Rev. A  12-27-06

© 2007 Copyright Magnadyne Corporation

The DVU-2 comes with flat head screws to facilitate mounting

the unit to the dashboard or some other accessible area in the

vehicle.

1. Attached the mounting tabs to the unit with the screws

provided.

2. Once tabs are attached use remaining screws to mount

unit in an accessible area.

The DVU-2 comes with a Velcro pad for mounting the unit to the

dashboard or some other accessible area in the vehicle. 

1. Make sure the surface area on the unit where the Velcro will

adhere to, and the surface you are adhering it to are clean. 

2. Remove the backing on one side of the Velcro pad.

3. Apply the Velcro pad to specified area on the unit.

4. Remove the backing on the other side of the Velcro pad and

then press the unit firmly into the designated mounting 

location.

The DVU-2 VPA plug can be removed to allow for hard wiring of

the unit when permanently installing it in a vehicle. 

1. Cut off the VPA connector making sure to leave the appro-

priate length of cable to reach your connection point.

2. Connect the red stripped wire to a fused 20A power source. 

3. Connect the black wire to chassis ground.