Lightwave Communications 2X16 Manuel D’Utilisation
Lightwave Communications
PC ServerSwitch 2x16
www.lightwavecom.com
Page 12 of 24
3.2.1 System Setup: Port Setup
Edit Port Names - Select the desired port using the up and down arrows and the
“Enter” key. Press 'Esc' to return to the previous menu screen.
“Enter” key. Press 'Esc' to return to the previous menu screen.
Port Setup
Edit Port Names
Edit Port Names
+Port 1
+Port 2 Default is blank
+Port 3 Enter a Port
+Port 4 Name here;
+Port 5 alpha-numerics
+Port 6 and
-Port 7 + - / . ; are OK
+Port 8 15 characters
F8 toggles Inactive msg +/-
keypad + or - toggles autoscan
Enter to edit a port name
keypad + or - toggles autoscan
Enter to edit a port name
; Port Autoscan Enabled
P
rev unit
D
own
Enter any name, up to 15 characters long. Note that case-sensitivity of port names
may be enabled or disabled system-wide, if required. Valid characters include A
through Z, a through z, digits 1 through 9 and 0, and + (plus), - (minus), / (slash),
. (period) and : (colon).
may be enabled or disabled system-wide, if required. Valid characters include A
through Z, a through z, digits 1 through 9 and 0, and + (plus), - (minus), / (slash),
. (period) and : (colon).
•
The
symbol on-screen represents Auto Scan Enabled for this port. A
Port with the
symbol showing will be included in a scan of active ports.
Select which ports should be scanned during auto scan mode (default is all
ports). Toggle auto scan on/off for each port using the + or - keys.
ports). Toggle auto scan on/off for each port using the + or - keys.
•
The + and - symbol before the Port number shows the LCD Inactive
message status (+ indicates that the front panel LCD will display an error
message for this port, - indicates that the front panel error message is
disabled for this port). To change this setting, select the Port and press F8
to turn this option On or Off.
message for this port, - indicates that the front panel error message is
disabled for this port). To change this setting, select the Port and press F8
to turn this option On or Off.
Note:
Refer to Section 3.1.1 for Auto-Scan system setup options.