Elica EAR628S2 Manuel De Montage

The hood insert is designed to remove smoke, cooking 

vapors and odors from the cooktop area. For best results, 

start the hood before cooking and allow it to operate several 

minutes after the cooking is complete to clear all smoke and 

odors from the kitchen.

The hood controls are located on the underside of the hood 

insert.

 

 

Turn the light switch (A) to the left 1 position tu turn the light 

ON.

Turn the light switch (A) to the right 1 postion to turn the light 

OFF.

The fan has 4 speeds. Rotate the fan switch (B) to the left to 

turn the fan to the ON position. Continue to rotate the switch 

to the desired fan speed.

To turn the fan OFF, rotate the fan speed (B) switch to the 

right to the OFF position. 
WARNING: The internal blower  motor of the hood is ther-

mally protected against high temperatures.

If the hood insert is not turned on during the cooking process, 

high temperatures could be present inside the hood and the 

motor could not work until the temperature is safe. The hood 

insert should be turned on during cooking operations. 

 

 

IMPORTANT: Clean the hood insert and grease filters 

frequently according to the following instructions. Replace 

grease filters before operating hood insert.

To avoid damage to the exterior surface, do not use steel 

wool or soap-filled scouring pads.

Always wipe dry to avoid water marks.

 

Liquid detergent soap and water, or all-purpose cleaner.

Wipe with damp soft cloth or nonabrasive sponge, 

 

then rinse with clean water and wipe dry. 

 

The filters should be washed frequently. Place metal filters in

dishwasher or hot detergent solution to clean.

Let filter dry thoroughly before replacing it.

Turn off fan and lights. Allow halogen lamp to cool. 

•

•

A. Light control                                 B. Fan control

Remove each filter by pulling the spring release handle 

 

and then pulling down the filter. 

 
 
 
 
 
 
 
 
 
 
 
 
 

Wash metal filters as needed in dishwasher or hot  

 

detergent solution.
Reinstall the filter by making sure the spring release 

 

handles are toward the front. Insert metal grease filter 

 

into upper track.
Pull the spring release handle down.
Push up on metal filter and release handle to latch into 

 

place. 

Turn off the range hood and allow the halogen lamp to cool. 

To avoid damage or decreasing the life of the new bulb, do 

not touch bulb with bare fingers. Replace bulb, using tissue or 

wearing cotton gloves to handle bulb.

If new lamps do not operate, make sure the lamps are in-

serted correctly before calling service. 

Disconnect power.
Push up on the lens and turn  

 

it counterclockwise.
Remove the bulb and replace  

 

it with a 120-volt, 50-watt  

 

maximum halogen bulb with a  

 

GU10 base. Turn it clockwise  

 

to lock it into place.
Repeat steps 2-3 for the other  

 

bulb if needed.
Reconnect power.

1.

2.

3.

4.
5.

1.
2.

3.

4.

5.

A

A.Spring Release Handle