Elica ETB430S1 Manuel De Montage

Observe all governing codes and ordinances.

It is the customer’s responsibility:

To contact a qualified electrical installer.

To assure that the electrical installation is adequate and in

conformance with National Electrical Code, ANSI/NFPA 70

— latest edition*, or CSA Standards C22.1-94, Canadian

Electrical Code, Part 1 and C22.2 No.0-M91 - latest

edition** and all local codes and ordinances.

If codes permit and a separate ground wire is used, it is

recommended that a qualified electrician determine that the

ground path is adequate.

Do not ground to a gas pipe.

Check with a qualified electrician if you are not sure range

hood is properly grounded.

Do not have a fuse in the neutral or ground circuit.

Save Installation Instructions for electrical inspector’s use.

The range hood must be connected with copper wire only.

The range hood should be connected directly to the fused

disconnect (Or circuit breaker) box through metal electrical

conduit.

Wire sizes must conform to the requirements of the National

Electrical Code ANSI/NFPA 70 — latest edition*, or CSA

Standards C22.1-94, Canadian Electrical Code Part 1 and

C22.2 No. 0-M91 - latest edition** and all local codes and

ordinances.

A U.L.- or C.S.A.-listed conduit connector must be provided

at each end of the power supply conduit (at the range hood

and at the junction box).

Copies of the standards listed may be obtained from:

* National Fire Protection Association Batterymarch Park Quincy,

Massachusetts 02269

** CSA International 8501 East Pleasant Valley Road Cleveland,

Ohio 44131-5575

These vent hoods must be power supplied 120 V, 60 Hz, 

 

and connected to an individual, properly grounded branch 

circuit, and protected by 15 or 20 Amps circuit breaker or 

 

fuse.

Wiring must be two wire with ground.

If the electrical supply does not meet above requirements, 

 

call a licensed electrician before proceeding.

Route house wiring as close to the installation location as 

 

possible, in the ceiling or back wall.

The hood must be connected to the house wiring in  

 

accordance with the local codes. 

 

CAUTION: This appliance should be properly grounded.

•

•

•

•

•