Dacor ER30DSRSCHLPH Manuel De Montage

Planning the Installation

Cabinet Layout

• 

Carefully check the location where the range is to be 

installed. For best performance, the range should be placed 

away from drafts that may be caused by doors, windows and 

heating and air conditioning outlets.

• 

To reduce the risk of personal injury and to reduce 

accumulated smoke in the room, Dacor strongly recommends 

installing a range hood. A range hood should project 

horizontally a minimum of five (5) inches beyond the face of 

the cabinets.

• 

All maximum and minimum dimensions and clearances 

shown in the diagram below and on page 8 (as 

applicable) must be maintained for safe operation.

• 

In the freestanding configuration, the range may be installed 

flush to the rear wall. For all installations, Dacor highly 

recommends installing a non-combustible material on the rear 

wall above the range and up to the vent hood or installation 

of a backguard. It is not necessary to install non-combustible 

materials behind the range below the countertop height.

• 

Any openings in the wall behind the appliance or in the floor 

underneath it must be sealed.

Gas and Electrical Service

• 

The shaded area shown denotes the location of the gas 

inlet and the electrical junction box/receptacle. This is the 

recommended location. For replacement purposes, the 

location of the existing utilities may be utilized provided they 

do not interfere with the sides or rear of the range. Check 

local building codes for permissible gas valve locations.

• 

An external manual shut-off valve must be installed between 

the gas inlet and the range for the purpose of turning on or 

shutting off gas to the appliance.

• 

Access to the gas shut-off valve when the unit is installed.

• 

Access to the remote circuit breaker panel or fuse box, when 

the range is in place.

• 

The gas supply piping, gas shut-off valve and the electrical 

junction box or receptacle must be located so they do not 

interfere with the range when it is installed.

• 

The junction box and gas shut off valve must be located 

so that the range can be pulled out for service while the 

appliance remains connected.

Note 2

F

G

2

 Cabinet/countertop depth is at discretion of customer but 

cabinet face MUST NOT protrude further than rear of front 

panel, see product dimensions.

3

 Vertical distance from range top panel level.

1

 Vertical to combustible surface from range grate level; if 

installing an overhead vent hood, also check the hood 

specifications for minimum required clearances. 

Non-combustible 

surface along 

back wall

recommended

10” (25.4 cm) min.

to combustible side

walls above the range

(both sides)

30” (76.2  cm)

min.

1

36 1/2” 

(92.7 cm)

max.

13” (33.0 cm)

max.

4

18” (45.7 cm)

min.

3, 4

Suggested 

location of 

utilities

 

3

4

 This specification does not apply for cabinets more 

than a horizontal distance of 10” (25.4 cm) from the 

edge of the range.

Cutout tolerances: +1/16” (+1.6 mm), -0

36” (91.4 cm)* 

30” (76.2 cm)**

30 1/16” (76.4 cm)*

* Recommended 

** Minimum

See following page for self-rimming cutout 

dimensions.

Do not operate the range without the backguard in place if the 

back wall is made of combustible materials. A fire may result.