GE GTV21ESSJWW Fiche Technique

Listed by 

Underwriters 

Laboratories

For answers to your Monogram,

® 

GE Profile

™

 or  

GE

®

 appliance questions, visit our website at 

geappliances.com or call GE Answer Center

®

 

service, 800.626.2000.

GTV21ESSJ 

GE

® 

7.0 cu. ft. capacity Dura Drum electric dryer with 150 ft. long venting

Exhaust Options: 

3-way via rear, right and bottom.

NEMA Receptacle codes: 

3-prong dryer cord/30A/4' long (cat #WX9X2) is for NEMA10-30R receptacle
4-prong dryer cord/30A/4' long (cat #WX9X18) is for NEMA14-30R receptacle
Circuit Requirements: 

An individual, properly-grounded branch circuit, protected by a 30-amp circuit breaker or a 

time-delay fuse, is required.

Electric Dryer Rating:  

240V, 5600W, 24A, 60Hz 

208V, 4400W, 22A, 60Hz
Note: Dryer wall outlet must be located within 36" of service cord entry and accessible 

when dryer is mounted in position.
Installation Information: For complete information, see installation  

instructions packed with your dryer.

Special Installation Requirements
Alcove or Closet Installation: 

•  If your dryer is approved for installation in an alcove or closet, it will be stated on a 

label on the dryer back.

• The dryer MUST be exhausted to the outside. 

•  Minimum clearances between dryer cabinet and adjacent walls or other surfaces 

are:

 

0" either side 

 

3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52". 

•  Closet doors must be louvered or otherwise ventilated and must contain a mini-

mum of 60 sq. in. of open area equally distributed. If this closet contains both a 

washer and a dryer, doors must contain  

a minimum of 120 sq. in. of open area equally distributed.

•  No other fuel-burning appliance shall be installed in the same closet with a gas 

dryer.

• The dryer MUST be exhausted to the outdoors. 

•  The installation must conform with the local codes, or in the absence of local 

codes, with the National Electric Code and National Fuel Gas Code, ANSI Z223 for 

gas dryers.

•  Minimum clearances to combustible surfaces 

  0" both sides 

  3" rear