Whirlpool WFG515S0EW Utilisation Et Entretien

Air in the gas lines.

If this is the first time the oven has been used, turn on any one 
of the surface burner knobs to release air from the gas lines.

Control is locked.

Press and hold START for 3 seconds to unlock.

Control is in Demo Mode.

Press and hold START TIME for 10 seconds to exit Demo 
Mode. Demo Mode is used for display models in a showroom.

Electronic oven control set 
incorrectly.

See “Electronic Oven Controls” section.

Range converted improperly.

If propane gas is being used, contact a service technician or 
see cover for contact information.

Oven temperature needs 
adjustment.

See “Oven Temperature Control” in the “Electronic Oven 
Controls” section.

The convection cycle is in the first 
5 minutes of operation.

This is normal. The convection fan will start running 
approximately 5 minutes into the cycle.

Oven door is open.

If the oven door is opened during convention cooking, the fan 
will turn off immediately. It will come back on when the oven 
door is closed.

Power failure (display shows 
flashing time).

Clear the display. On some models, reset the clock, if needed. 
See “Clock” keypad feature in the “Feature Guide” section.

Error code (display shows letter 
followed by number).

Depending on your model, press CANCEL to clear the display. 
See “Control Display” in the “Electronic Oven Controls” 
section. If it reappears, call for service. See cover for contact 
information.

Start needs to be pressed so a 
cycle can begin (display shows 
“PUSH” or “PSH”).

See the “Start” keypad feature in the “Feature Guide” section.

Range is in Sabbath Mode 
(display shows “SAb”).

Press CANCEL to exit Sabbath Mode.

The oven door is not closed.

Make sure the oven door is fully closed.

The Self-Cleaning function has 
not been entered correctly.

See the “Self-Cleaning Cycle” section.

A Timed Cooking function has 
been entered.

See the “Cook Time” section.

The range is in Sabbath Mode.

See the “Sabbath Mode” section.

A Self-Cleaning cycle has been 
run in the past 12 hours.

If a Self-Cleaning cycle has been run, or has been canceled 
after the oven reached temperature, the oven control requires a 

 

12-hour delay before starting another Self-Cleaning cycle.