GE GTD18GSSJWW Fiche Technique

GTD18GSSJ 

GE

®

 6.8 cu. ft. capacity Dura Drum gas dryer

For answers to your Monogram,

® 

GE Profile

™

 or  

GE

®

 appliance questions, visit our website at 

ge.com or call GE Answer Center

®

 service,  

800.626.2000.

Listed by 

Underwriters 

Laboratories

Exhaust Options: When viewed from the front of the unit, exhaust 3-way 
via rear, left and bottom. Dryer is shipped exhausted to the rear. Alternate 
exhausting knockouts are supplied. 
Electric: An individual, properly-grounded branch circuit, with a three-prong 
grounding-type receptacle, protected by a 15 or 20 amp circuit breaker or a 
time-delay fuse, is required. 
Gas Dryer Electric Rating: 120V, 60Hz, 6A
Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP gas. 
LP gas supply requires a conversion kit. Check installation instructions for 
correct kit and have a qualified gas technician install a conversion kit.  
See dryer ducting information for proper installation. 
Note: Dryer wall outlet must be located within 36” of service cord entry and 
accessible when dryer is mounted in position. 
Installation Information: For complete information, see installation  
instructions packed with your dryer.

• If your dryer is approved for installation in an alcove or closet, it will be stated on

a label on the dryer back.

• The dryer MUST be exhausted to the outside
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces

are: 0" either side and 3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
• Closet doors must be louvered or otherwise ventilated and must contain a  

minimum of 60 sq. in. of open area equally distributed. If this closet contains both
a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area 
equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a  

gas dryer.