AGA ADC5GDEB Fiche Technique

  

The hotcupboard attachment requires an independent single 

phase supply. It has a maximum load of 6 amps, protected by an 

appropriate branch circuit supply. 110/120V FLEXIBLE CORD and 

PLUG PARALLEL TYPE (NEMA 5-15P). The appliance when installed 

must be electrically grounded with local or regional codes.

An electrical socket must be provided within 5 feet of the LH side 

of the appliance and easily accessible for the user to disconnect. 

Do not position the socket above the appliance. See Fig. 5A.

Take special care when cutting holes in wall or floor. Electrical 

wires may be behind the wall or floor covering and could cause 

an electrical shock if you touch them. Locate any electrical circuits 

that could be affected by the installation of this product and 

disconnect power circuit.

This appliance is equipped with a NEMA 5-15P grounded plug for 

your protection against a shock hazard and should be plugged 

directly into a proper receptacle. Do not cut or remove the 

grounding prong from this plug.

Do not have a fuse in the neutral or grounding circuit. A fuse in 

the neutral or grounding circuit could result in electrical shock.

Do not use an extension lead with this appliance. Check with a 

qualified electrician, if you are not sure the appliance is properly 

grounded. Failure to follow these instructions could result in 

death or serious injury.

Specifications are subject to change without notice.  Visit www.aga-ranges.com for the most up-to-date information.