Marvel 30IMTSSF Manuel D’Utilisation

4.    Remove the drain plug at the bottom of the reservoir to 

        drain any remaining water and then reinstall.

5.     Allow the ice to fall from the evaporator, remove and dis-

        card slab of ice. (See figures 21 and 22).

6.   Determine the proper amount of cleaner from the ice ma-

       chine cleaner manufacturer’s mixture ratio based on 3/4 gallon

      (2.81 liters) of water (refer to the manufacturer’s mix ratio 

      directions). Add the recommended amount of concentrated 

      cleaning solution to the reservoir of the ice machine. This can

      be done by pouring the solution on the evaporator, which will 

      flow down into the reservoir. (See figure 23). 

7.   Switch the selector switch on the grille of the ice machine to

      the “CLEAN” position. The ice machine will automatically 

      start and stop the cleaning cycle and ¾ of a gallon (2.81 liters)

      of water will automatically be added to the cleaning solu-

      tion.

8.   The total cleaning time will end in 49 minutes.  The cleaning

      cycle will automatically rinse the evaporator plate and also 

      drain the cleaning solution and rinse the reservoir with water.

9.  After the cleaning cycle has ended check that the build-up has

     been removed.  The evaporator plate should be clean, shiny, 

     and smooth to the touch.  If build-up is still visible, repeat the

     cleaning cycle above.

10. Clean the ice machine’s interior, ice scoop, interior door 

     panel and door gasket with mild soap and water. Using two (2)

     tablespoons of baking soda in one (1) quart of warm water 

     while cleaning will help remove odors. Rinse with fresh water. 

     DO NOT USE ANY ABRASIVE CLEANING PRODUCTS.

11. Replace the front panel.

12. Your ice machine is now clean and sanitized and may be put

      back into operation by switching the selector switch to the

      “ON” position.

Drain plug 

in bottom of 

reservoir.

Figure 20

Figure 23

Discard the first batch of ice.

In the unlikely event a power 

interrupt occurs during the clean cycle, you need to start over 

from the beginning to assure complete cleaning and rinsing of 

the cleaning agent from the machine. 

18

Figure 21

Allow ice slab 

to  fall on to grid 

cutter

Figure 22

Remove ice 

slab and 

discard