Whirlpool WEG760H0DS Manuel De Montage

4. Remove 2 screws from the bake burner.

5. Slide the front of the bake burner to the side to remove tab 

from front of oven. Lift the back of the bake burner off the 
oven orifice, and set the bake burner aside. Do not 
disconnect the wire.

6. Apply masking tape to the end of a 

³⁄₈" (1 cm) nut driver to 

help hold the gas orifice spud in the nut driver while changing 
it. Press nut driver down onto the gas orifice spud and 
remove by turning the LP gas bake burner orifice spud 
counterclockwise to remove. The spud will be stamped with a 
“56.”

7. Replace the “56” spud with a “47” spud. Install the Natural 

gas bake burner orifice spud, turning it clockwise until snug.

IMPORTANT: Do not overtighten.

8. Position the back of the bake burner over the oven orifice, 

and then align the holes for the screws.

9. Reattach the bake burner with 2 screws.

10. Position the front of the oven bottom panel toward the front 

frame, and then lower the rear of the oven bottom panel into 
the oven.

11. Reattach the oven bottom panel with 2 screws and 

2 washers.

1. Remove 1 screw from the broil burner.

2. Remove the flame spreader.

3. Remove the broil burner from the broil burner orifice hood.

NOTE: The broil burner will hang in the back of the oven while 
you are changing the orifice hood.

4. Apply masking tape to the end of a 

³⁄₈" (1 cm) nut driver to 

help hold the gas orifice spud in the nut driver while changing 
it. Press nut driver down onto the gas orifice spud and 
remove by turning the LP gas broil burner orifice hood 
counterclockwise to remove. The hood will be stamped with 
a “100.”

5. Replace the “100” hood with a “155” hood. Install the Natural 

gas broiler burner orifice hood, turning it clockwise until snug.

IMPORTANT: Do not overtighten.

6. Place the broil burner on the broil burner orifice hood. Insert 

the broil burner ceramic igniter in the hole in the rear of the 
oven.

7. Replace the flame spreader with all 4 tabs facing up and the 

notches toward the rear of the oven.

8. Position the broil burner against the top of the oven and 

attach it with 1 screw.

A

B

A

A

C

D

A

B

x.xx

A