Bosch NET8066SUC Manuel

17

▯

The cooktop regulates the heating element 

temperature by turning the heat source on and off; this 

means that the reddish glow of the heat source 

beneath the heating element may not always be 

visible. If you select a low heat setting, the heat source 

is frequently off; at higher settings it is seldom off. The 

source turns on and off even at the highest settings.

▯

You may hear a quiet hum when the heating elements 

are in the heating phase. The heating elements may 

glow with different levels of brightness. Depending on 

the angle from which you are looking at the heating 

element, this glow may be visible over the marked 

edge of the heating element. These are technical 

characteristics. They have no effect on quality and 

function.

▯

Glass ceramic may have uneven areas on the surface 

due to the nature of the material itself. Because of the 

mirror-like finish on the cooking surface, even 

extremely small bubbles less than 1 mm in diameter 

may be visible. These bubbles will not have any 

adverse effect on the operation of the cooktop nor on 

the durability of the glass ceramic cooking surface.

▯

Depending on the countertop that is present in the 

kitchen, an uneven gap between the cooktop unit and 

the countertop can occur. For this reason, a flexible 

seal is provided around the entire cooktop unit.

Contact our Technical Service Department if your 

appliance needs repair. Our central Customer Service 

Center (see below) will also be happy to supply you with 

details on a center close to you.
E number and FD number:
When you contact our service, please have the Model(E) 

number and the FD number for your appliance available. 

You can find the identification plate with these numbers 

on the underside of the appliance and in the appliance 

booklet.
Questions? Please contact us. We look forward to 

hearing from you!

”† 

 and the heat 

setting flash alter-

nately. An audible 

signal can be 

heard

Warning: There is a hot pot in the 

area of the control panel. There is a 

risk that the electronics will overheat.

Remove the pot. The fault display goes out shortly after-

wards. You can continue cooking.

”† 

and audible 

signal

There is a hot pot in the area of the 

control panel. To protect the elec-

tronics, the cooking zone has been 

switched off.

Remove the pot. Wait a while. Touch any control. When 

Ӡ

 goes out, you can continue cooking.

”‰

The cooking zone was in operation 

for too long and has switched itself 

off.

You can switch the cooking zone back on again immedi-

ately.

0DLQ6WUHHW6XLWH

,UYLQH&$

ZZZERVFKKRPHFRP