Marvel M24DZBGXR Manuel De Montage
12
LEVELING THE UNIT AND INSTALLING THE POWER MODULE
Leveling the unit:
Unit MUST be installed level in all planes, on a floor that
is strong enough to support a fully loaded wine cellar. See
Figure 9.
This unit is equipped with front and rear rollers. Rollers will
aid during installation. Rear rollers are adjustable from the
front of the unit. Total adjustment is +
5
⁄
16
, -
5
⁄
16
. Turn
adjusting bolt with a
7
⁄
16
" wrench clockwise to raise cabinet
and counterclockwise to lower cabinet. See Figure 10.
Front leveling legs must be adjusted to the floor for leveling
and to prevent the unit from rolling during use. See
Figure 10.
NOTE
Figure 9
Figure 10
-Rear Roller Adjustment Bolt
(Use
7
⁄
16
open end wrench or
socket and ratchet)-
-Both front leveling legs must be
adjusted to floor after leveling
Front
leveling
leg-
Placing power module on top of cabinet:
Place module on top of the cabinet with rear shoulder
screws resting on the locator brackets behind the front
slots. Slide module toward the rear of the cabinet until the
rear shoulder screws engage the slots in the rear of the
brackets. Rest the front shoulder screws into the front slots
of the brackets.
Check to make sure the wiring is clear and not interfering
with module seal. Do NOT start product during construc-
tion, as dust can block module condenser coils. If dust
accumulates on coils, vacuum immediately, using a soft
brush attachment.
NOTE