Gaggenau VG231214CA Manuel De Montage
8
Some yellow streaking is normal during the initial
star t-up. Allow unit to operate 4-5 minutes and re-
evaluate before making adjustments.
star t-up. Allow unit to operate 4-5 minutes and re-
evaluate before making adjustments.
Removing the appliance
Disconnect the appliance from the power and the gas
supply. Push out the appliance from below.
supply. Push out the appliance from below.
,
CAUTION:
Risk of damage! Do not lever out the
appliance from above.
Conversion to another type of gas
This gas stovetop corresponds to the categories
specified on the rating plate. By changing nozzles, it
is possible to conver t the appliance to any of the
gases listed on the plate. The conversion kit can be
obtained from our customer ser vice. With some
models, the conversion kit is included in the scope of
delivery.
specified on the rating plate. By changing nozzles, it
is possible to conver t the appliance to any of the
gases listed on the plate. The conversion kit can be
obtained from our customer ser vice. With some
models, the conversion kit is included in the scope of
delivery.
Only a licensed specialist is authorized to switch the
appliance to another gas type.
appliance to another gas type.
Before carrying out the conversion, turn of f the
electricity and gas supply.
electricity and gas supply.
Changing the low burn nozzle:
1
1
Remove pan suppor t and all burner parts.
2
Unscrew two fastening screws (Tor x T20) and
remove stovetop.
remove stovetop.
3
Remove control knob. Remove control panel:
Unscrew the two upper, lateral fastening screws
(Torx T20). Raise control panel in the rear and
push it for ward. Remove switch cover.
Unscrew the two upper, lateral fastening screws
(Torx T20). Raise control panel in the rear and
push it for ward. Remove switch cover.
4
The low burn nozzle is located in the gas valve
and is screwed in from above. For easier
accessibility, turn switch or remove securing ring
and remove switch. Unscrew the nozzle and inser t
the new nozzle as specified in the low -setting
nozzle table. The nozzle must be screwed in fully.
and is screwed in from above. For easier
accessibility, turn switch or remove securing ring
and remove switch. Unscrew the nozzle and inser t
the new nozzle as specified in the low -setting
nozzle table. The nozzle must be screwed in fully.
5
Put switch, securing ring, switch cover and
control panel back in place and screw them tight.
Put on control knob.
control panel back in place and screw them tight.
Put on control knob.
Changing the full burn nozzle:
1
1
Remove securing clips on the burner pipes.
Remove burner pipes. Loosen screw on air-
regulating tube. Remove nozzle fitting.
Remove burner pipes. Loosen screw on air-
regulating tube. Remove nozzle fitting.
2
Remove nozzle and O-ring for inner circular
burner by hand. Unscrew nozzle for outer circular
burner (SW10).
burner by hand. Unscrew nozzle for outer circular
burner (SW10).
$
%