Summit MRF41ES Manuel Du Propriétaire

 
 
To use the refrigerator with the most efficiency and safety, select a suitable place to 
install it  according to the following guidelines: 

1.  This refrigerator is designed for free-standing installation only and should not be 

recessed or built in. 

2.  The refrigerator should be installed on a sturdy, level floor or counter. If the floor 

is not quite level, adjust the front feet of the unit. 

3.  Allow 4 inches of space between the back of the refrigerator and the wall behind. 
4.  Avoid any direct sunlight, heat or moisture. 
5.  The refrigerator is equipped with a three-prong plug and is grounded to minimize 

electrical hazards. To make it effective, the refrigerator must be plugged into a 
grounded electrical socket. 

6.  Do not use an extension cord. 

 

 
Before using the refrigerator, clean it and make a test run to see if it follows the behavior 
described here.  If not, check the electricity supply. If the cause of the trouble cannot be 
located, contact your Summit dealer. 
 

1.  Set the Temperature Control Knob at the OFF position and then plug the power 

cord into an electrical outlet of 115 volts, 60Hz.  The compressor should not run. 

2.  Set the Temperature Control Knob at the MAX position and let the refrigerator 

operate for 20 minutes. The freezer compartment should get slightly frosted and 
the compressor should run smoothly with no noise but a soft hum. 

3.  Then rotate the Temperature Control Knob counter-clockwise toward the MIN 

position. Before the pointer of the knob reaches MIN, the compressor should turn 
off. 

 
 

ATTENTION 

Your refrigerator is equipped with a special thermostat control 
device.  If the unit is turned off or unplugged, YOU MUST 
ALLOW THREE (3) MINUTES BEFORE RESTARTING OR 
REPLUGGING THE UNIT. 

The unit will not start if you attempt to restart it in less than 
three (3) minutes. 

 
 
 
 
 
 
 

 

 

 

5