Movincool CM25 Instruction De Maintenance

Repair Section

88

• Reassemble the unit in the reverse order of removal. Described below are the parts that require special

care in reassembling the unit. Perform all wiring or rewiring as referenced in the wiring diagram.

• Mount the compressor on the frame, using

cushions, steel collars, plate washers, and

nuts.

• Install the evaporator fan. Allow a clearance of 0.12 inch (3.0 mm) or more on each side of the

evaporator fan. (See page 72.)

< NOTE >

Initialize the fan motor after replacement. (See page 61.)

• Install the condenser fan. Allow a clearance of 0.12 inch (3.0 mm) or more on each side of the

condenser fan. (See page 74.)

< NOTE >

Initialize the fan motor after replacement. (See page 61.)

• Secure the wires using clamps so that they do not come into contact with the edges of the

structure. Secure the wires using clamps in the same position they were before removal.

• Perform an inspection of cooling performance and check for abnormal noise or vibration.

ILL00178-00

Nut

Steel Collar

Cushion

Plate Washer