Dacor METB3651 Guide De Montage

Below Countertop Preparation

WARNING:

Failure to provide proper

clearances may result in a fire

hazard!

NOTES:

1. Plastic or other utensils with

low melting temperatures

should not be stored in

drawers immediately below

the cooktop.

2. Access to the underside of

the cooktop and the junction

box must be provided for

inspection and service.

All models are designed for standard 24-inch-

deep (610mm) base cabinets with 25-inch

(635mm) overall depth countertops. Before

making the countertop cutout, make certain that

the cooktop will clear the front and side walls

of the base cabinet as shown. Clearance is

required for proper fastening of the cooktop hold

down brackets.

Also allow a minmimum 2-inch (51mm)

clearance between the bottom of the cooktop

chassis and any combustible surface, including

the upper edge of a drawer installed below the

cooktop.

Locate the junction box within reach of the

included 48-inch-long (1219mm) cooktop power

lead such that the junction box is accessible

when the cooktop is in place.

Installing the Cooktop

WARNING:

Do not use a hardening

compound or caulking to

permanently seal the cooktop into

place, as the unit must be readily

removable for service. If such a

hardening compound is used,

removal of the unit will be at the

customer’s expense.

Attach the foam tape provided with the unit to

the underside of the cooktop frame. Place and

center the cooktop within the cutout. Secure the

cooktop to the countertop utilizing the two (2)

hold-down brackets provided. Slide the brackets

into the slots located on the left and right sides

of the chassis, then tighten the screws to the

underside of the countertop.

Glass Top and

Frame

Foam Tape Seal

Countertop

4“ (102mm)

Hold Down Bracket

and Screw

Cooktop Installation

Section View

Electrical Connection

WARNINGS:

1. Ensure that the power supply

is disconnected before

proceeding.

2. Verify that the power supply

matches the ratings found on

the appliance data plate before

proceeding.

3. The complete appliance must

be properly grounded at all

times when electrical power is

applied.

4. Do not ground the appliance

with the neutral (white) house

supply wire. A separate

ground wire must be utilized.

5. If aluminum house supply

wiring is utilized, splice the

appliance copper wires to the

aluminum house wiring using

special connectors designed

and agency-certified for

joining copper and aluminum.

6. Follow the connector

manufacturer’s recommended

procedure carefully. Improper

connection can result in a fire

hazard!

These products are provided with a flexible

conduit consisting of two (2) insulated hot lead

conductors (both copper) and one (1) insulated

ground conductor (copper).

For UL installations attach the conductors to the

residence wiring in accordance with National

Electric Codes and all state, municipal and local

codes.

Verifying Proper Operation

WARNINGS:

1. Never touch any heating

elements when the power is

on.

2. If the cooktop glass is broken,

turn off power to the unit. Do

not operate until glass has

been replaced by a qualified

service technician.

3. This product must be repaired

only by a qualified service

technician. Unit must be

disconnected from power

prior to service.

NOTES:

Before operating the unit:

1. Clean the glass surface

carefully using the Cooktop

Cleaning Creme provided

with the product. Remove all

cleaner residue.

2. Read and understand the

accompanying Use and

Care Manual. Important

safety, service and warranty

information is contained

within the manual.

If all final electrical connections are complete

as indicated, then proceed to turn on the power.

Once the power is on, test each burner position

for correct operation.

Any problems should be reported immediately to

your installer or an authorized Dacor servicer.