BlueStar RGTNB304BV2 Manuel

Page de 32
 
 
16
OPERATION 
 
OPEN TOP BURNERS 
 
Start-Up 
Remove the ring grates and top grates and thoroughly wash them with hot, soapy water, rinse, and dry 
immediately.  Extended exposure to moisture may cause rusting of exposed metal surfaces. Each top grate 
section has four leveling screws, which may be used to level your grates.     
 
Operation 
To light an open top burner, push, then turn the appropriate control knob to the "HIGH" position.  This 
control is both a gas valve and an electric switch.  When the knob is placed in the "HIGH" position, which 
is required for lighting all burners, gas is permitted to flow to the burner, and the igniter will begin sparking 
with a "clicking" sound.  If you do not hear this sound, turn the control knob to the "OFF" position and 
check to make sure that the unit is plugged in and that the fuse or circuit breaker on the service line is not 
blown or tripped.  It is possible that multiple igniters will spark.  Any additional troubleshooting of unit will 
require an authorized service technician.   
 
NOTE:  Do not operate this unit between 
“high” and “off”!  If the flame extinguishes, re-
ignition will not occur and gas will leak. 
After a few seconds of sparking, enough gas will 
have traveled through the burner to achieve ignition. 
There is no pilot burner. The igniter lights the burner 
directly. 
 
After the burner lights, set the burner control knob to any position between the "HIGH" and "LOW" settings 
to adjust the flame height to your desired cooking specifications. All open top burners are equipped with 
automatic re-ignition, which will re-light the burner if it goes out for any reason. 
 
1/2"
 
Clean-Up 
 
The ring grates and top grates on your unit are coated with a porcelain enamel that may be effectively 
cleaned with hot soapy water. 
 
In the event that heavy soiling occurs, a commercial oven cleaner may be used on these parts. Be sure to 
follow the manufacturer's instructions carefully, and to avoid the cleaner coming in contact with the 
painted surfaces of your unit. 
 
REMEMBER: To assure proper fit, replace top and ring grates in their original positions!
NOTE: All burners, including the 
simmer burner, must be ignited in 
the “HIGH” position.  
When set on 
"HIGH," the flames on the open top 
burners should be approximately 
1/2 inch high and burn with a sharp 
blue tip.  Some yellow may occur, 
depending on the gas type being 
supplied.