Vantec NexStar 3i Power Management NST-360S2I-WH Manuel D’Utilisation

7.2 Power Management mode introduction 

After installing the Power Management application, the program will automatically launch. 

The application will start to manage the power and the LED light indicates mode status. 

It’s the normal work status for data transfer, where the Hard Drive reaches the highest work 

speed and power consumption. 

a. The Hard Drive works normally. 

b. The blue

 

front panel flashes. 

If the hard drive is inactive for three seconds, the Power Management program will 

automatically switch the mode from Active to Idle. 

a. The Hard Drive waits for commands for three seconds. 

b. The Idle LED light flashes. 

If the hard drive is inactive for three minutes, the Power Management program will 

automatically switch the mode from Idle to Stand By.   

a. The Hard Drive waits for commands for three minutes. 

b. The Stand By LED light flashes 

If the hard drive is inactive for five minutes, the Power Management program will 

automatically switch the mode from Stand By to Power Down.. 

a. The Hard Drive waits for commands for five minutes. 

b. The Hard Drive stops working. 

c. The Power Down LED light flashes. 

 
 

 

 

Power Management Mode