Summit FS24 Manuel D'Instructions

 

 

  Before Using Your Freezer 

•  Remove the exterior and interior packing. 

•  Before connecting the freezer to the power source, let it stand upright for approximately 2 

hours. This will reduce the possibility of a malfunction in the cooling system from handling 
during transportation. 

•  Clean the interior surface with lukewarm water using a soft cloth. 

 

  Installing Your Freezer 

•  This appliance is designed to be free standing only, and should not be recessed or built-in. 

•  Place your freezer on a surface that is strong enough to support it when it is fully loaded. To 

level your appliance, adjust the leveling leg at the bottom of the freezer. 

•  Allow about 5” (12 cm) of space at the back and sides of the appliance and 4” (10 cm) at the 

top. This will allow the proper air circulation to cool the compressor. 

•  Locate the appliance away from direct sunlight and sources of heat (oven, heater, radiator, 

etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical 
consumption. Extremely cold ambient temperatures may also cause the freezer not to 
perform properly. 

•  Avoid locating the appliance in moist areas.  

•  Plug the appliance  into an exclusive, properly installed and grounded wall outlet. Do not 

under any circumstances cut or remove the third (ground) prong from the power cord. Any 
questions concerning power and/or grounding should be directed toward a certified 
electrician or an authorized service center. 

•  After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours 

before placing items inside the cabinet. 

 

  Electrical Connection 

 

 

 

 

 

Warning 

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord 
is damaged, have it replaced by an authorized service center.