Manualsbrain.com
  1. Manuels
  2. Marques
  3. GE
  4. JVM7195SFSS
  5. Manuel De Montage

GE JVM7195SFSS Manuel De Montage

Télécharger
Page de 48
13
MOUNT THE OVEN
A4
 
$66(0%/($1',167$//$'$3725
A3
 
86(723&$%,1(77(03/$7()25
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws,  
a hole large enough for the power cord to fit through, 
and a cutout large enough for the exhaust adaptor.
A2
Damper
Front of 
Oven
Back of Oven
Remove Screw from 
Back of Blower Plate
Remove Screw from 
Top of Blower Plate
‡  Read the instructions on the TOP CABINET TEMPLATE.
‡  Tape it underneath the top cabinet.
‡  Drill the holes, following the instructions on the TOP 
CABINET TEMPLATE.
CAUTION:
:HDUVDIHW\JRJJOHVZKHQ
GULOOLQJKROHVLQWKHFDELQHWERWWRP
Installation Instructions
  Place the oven in its upright position, with the top  
of the unit facing up and the front of the unit facing 
toward you.
  Remove the screw on the back side of the blower 
plate and raise the blower plate off of the microwave.
  Slide the damper from left to right into the tabs on the 
blower plate. The yellow tape on the damper should 
be facing you. If the blower plate is not raised off of 
the top of the microwave, the damper cannot slide 
into position.
  Remove the yellow tape from the damper. 0DNHVXUH
WKDWWKHGDPSHUSLYRWVHDVLO\EHIRUHPRXQWLQJRYHQ 
  You will need to make adjustments to assure proper 
alignment with your house exhaust duct after the 
oven is installed.
Exhaust 
Adaptor
1
2
Blower Plate
Tabs
3
4
CAUTION:
 7RDYRLGWKHULVNRISHUVRQDO
LQMXU\ EDFNLQMXU\RURWKHULQMXULHVGXHWRH[FHVVLYH
ZHLJKWRIWKHPLFURZDYH RUSURSHUW\GDPDJH\RX
ZLOOQHHGWZRSHRSOHWRLQVWDOOWKLVPLFURZDYH
IMPORTANT: Do not grip or use handle during 
installation.
WARNING:
 5LVNRI(OHFWULF6KRFN
&DQFDXVHLQMXU\RUGHDWK,ILQVWDOOLQJXQLW
ZLWKPHWDOFRXQWHUWRSVFRYHUWKHHGJHRIWKH
power supply cord hole with the power supply cord 
EXVKLQJ
IMPORTANT: If filler blocks are not used, case damage 
may occur from overtightening screws.
  Insert a self-aligning screw through top-center  
cabinet hole. Temporarily secure the oven by  
turning the screw at least two full turns after  
the threads have engaged. (It will be completely 
tightened later.) 
3
NOTE: When mounting  
the microwave, thread 
power cord through hole 
in bottom of top cabinet. 
Keep it tight throughout 
Steps 1–3. Do not pinch 
cord or lift oven by pulling 
cord.
Lift microwave, tilt it 
forward, and hook slots 
at back bottom edge 
onto four lower tabs of 
mounting plate.
1
2 Rotate front of oven up 
against cabinet bottom.