Samsung RF25HMEDBBC Utilisation Et Entretien

English - 11

01 SETTING 

UP

REMOVING THE 
REFRIGERATOR DOORS

For some installations, you need to remove the 
fridge doors and freezer drawer so you can 
move the refrigerator to its fi nal location. Do not 
remove the doors/drawers if you don’t need 
to. If you do not need to remove the refrigerator 
doors or drawers, go to ‘Adjusting the Level’ 
on page 14. If you need to remove the doors 
and drawers. continue below. Before removing 
the doors or drawers, make sure you read the 
following warnings:

WARNING

Disconnect power to the refrigerator before 
removing the door or drawer.

•  Be careful not to drop, damage, 

or scratch the doors/drawer while 
removing them.

•  Be careful not to injure yourself while removing 

the doors/drawer.

•  Reattach the doors/drawer properly to avoid:
-  Moisture from air leakage.
-  Uneven door alignment.
-  Wasting energy due to improper door seal.

WARNING

Disassembling the refrigerator doors

Be careful not to drop and scratch the doors while 
removing them.

With the door opened

1.  Remove the 3 screws holding down the TOP 

TABLE ( 1 ) and separate the connected wires.

1

2.  Disconnect the two connectors ( 2 ) on the 

left side door. To remove the water coupler 
from the hinge, twist and pull it from the hinge. 
Remove the water line ( 3 ) while pressing the 
marked part ( 4 ) of the water line coupler. 

CAUTION

If a red clip is on the coupler, you must remove it 
before removing the tube.

2

3

4

Red Clip 

Red Clip 

(1/4")

(1/4")

3.  Pull and remove the hinge lever ( 5 ). Remove 

the ground screw ( 6 ) attached to the upper 
left door hinges with a philips screwdriver (+). 
Remove the upper left and right door hinges 
( 7 ).

5

6

7

4.  Lift the door straight up to remove.

DA68-02952A-03.indb   11

DA68-02952A-03.indb   11

2014. 10. 13.   

 2:49

2014. 10. 13.   

 2:49