Samsung RF23HCEDBSR Manuel Du Propriétaire

Page de 140
English - 24
•  The app supports indoor control only.
•  The Samsung E-Smart Ref. app is optimized 
for Samsung Electronics Smartphones (Galaxy 
S4 , Galaxy Note 3).  
For other Smartphones, some functions may 
work differently.
MAC Address Display Mode
This function displays the MAC address of the Wi-
Fi module on the refrigerator display. 
The refrigerator displays the MAC address of the 
Wi-Fi module for 1 minute.
1.  Press and hold the Freezer and Energy Saver 
buttons at the same time for 3 seconds.
2.  A Buzzer sounds. Four of the twelve Mac 
address of the Wi-Fi module are displayed 
in turns in the freezer and fridge temperature 
displays for 1 minute.  
For example, if the Wi-Fi module’s MAC 
address is “11-22-33-44-55-66”, the MAC 
address is displayed as follows: “11 22” → “33 
44” → “55 66” → ---- → “11 22” for 1 minute.
3.  After 1 minute, the display returns to the normal 
state and the Buzzer sounds again.
If the Mac addresses are not available or 
there is no Wi-Fi module, `----’ is displayed 
on the freezer and fridge temperature 
displays.
SMART GRID Function 
(Demand Response)
When the refrigerator operates in SMART 
GRID (Demand Response) mode, the E-Smart 
Refrigerator function can control energy usage 
or delay the operation of some functions to save 
money when energy prices or demand are the 
highest, 
You can deactivate the SMART GRID 
(Demand Response) function at any 
time. (Using the Override On/Off 
function)
To use the SMART GRID (Demand 
Response) function, you need a 
separate contract with your electric 
Utility company. 
Using the SMART GRID (Demand 
Response) Function
This feature monitors energy prices and demand 
information from your utility company and sends 
notifications to the refrigerator to run high energy-
consuming tasks during off-peak times when 
electricity costs and demand are lower.  
If the refrigerator receives a control signal from 
the Utility Company, the refrigerator will display 
the DAL(L3) ~ TALR(L4) levels on the refrigerator 
display and control the power consumption 
according to the level. 
[Exception condition] The DAL and TALR control 
signals from an Utility Company work as long as 
product performance is maintained. 
If the refrigerator receives the SMART GRID 
(Demand Response) signal (DAL or TALR), 
the refrigerator will operate in Delay Appliance 
Load (Display:L3) or Temporary Appliance Load 
Reduction (Display:L4) mode.
DA68-02954A-03.indb   24
14. 10. 10.   �� 9:50