Whirlpool WSR57R18DM Utilisation Et Entretien

Page de 24
4
Refrigerator Door
Tools Needed: 
⁵⁄₁₆
" hex-head socket wrench, 
³⁄₈
" hex-head socket 
wrench, flat 2" putty knife.
IMPORTANT: 
Depending on the width of the opening, you may need to remove 
the handle or door to move the refrigerator into the house.
All graphics referenced in the following instructions are included 
later in this section after “Final Steps.” The graphic may be reversed 
if door swing is reversed.
Before you begin, turn the control OFF, and remove food and 
adjustable door or utility bins from door.
Remove and Replace the Handle
To Remove the Handle:
1. Loosen the setscrews located on the side of handle at each end. 
See Handle graphic.
2. Remove the handle from the grommets.
To Replace the Handle:
1. Place the handle onto the grommets making sure the grommets 
are fitted into the handle holes.
2. Tighten the upper and lower setscrews with the hex key provided. 
See Handle graphic. Do not overtighten the setscrews.
Remove Door and Hinges
Hinge screws
1. Unplug refrigerator or disconnect power.
2. Keep the refrigerator door closed until you are ready to lift it free 
from the cabinet.
NOTE: Provide additional support for the door while the hinges are 
being moved. Do not depend on the door magnets to hold the door 
in place while you are working.
3. Remove the parts for the top hinge as shown in Top Hinge graphic. 
4. Lift the refrigerator door free from the lower hinge and cabinet and 
set aside.
5. Remove the four hex-head hinge screws and bottom hinge 
assembly. See Bottom Hinge graphic.
Replace Door and Hinges
NOTE: Graphic may be reversed if door swing is reversed.
1. Replace the parts for the bottom hinge as shown and tighten 
screws. See Bottom Hinge graphic. Replace the refrigerator door.
NOTE: Provide additional support for the door while the hinges are 
being moved. Do not depend on the door magnets to hold the door 
in place while you are working.
2. Assemble the parts of the top hinge as shown in the Top Hinge 
graphic. Do not tighten the screws completely. 
Final Steps
1. Plug into a grounded 3 prong outlet.
2. Reset the control. See “Using the Control.”
3. Return all removable door parts to door and food to refrigerator.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, 
fire, or electrical shock.
WARNING