Monogram ZIC30GNHII Guide De Conception
80”
STEP 2 INSTALL ANTI-TIP BRACKET
• Inside Top Face of bracket should be installed at 80”.
“Slot” in bracket should to be placed in center of install
Space (Typically 15”)
• Mark (within slots, placement) stud and anchor positions
on brackets.
•Secure bracket using combination of studs & anchors.
•At least 1 stud must be engaged.However, please engage
•At least 1 stud must be engaged.However, please engage
as many studs as possible within the enclosure. A mininum
of three fasteners should be used for proper installation.
of three fasteners should be used for proper installation.
STEP 4 CONNECT POWER
• Plug the power cord into the socket.
• Check to make sure power to refrigerator is on by
• Check to make sure power to refrigerator is on by
opening the ice drawer (FF door will be banded shut)
to see if interior lights are on.
to see if interior lights are on.
• The temperature controls are preset at 37°F for the
fresh food section and 0°F in both the freezer drawer
and customizable drawer.
and customizable drawer.
• Allow 24 hours to stabilize before making
adjustments.
STEP 3 CONNECT WATER LINE
14
Installation Instructions
• Position appliance in front of enclosure.
• Locate and bring tubing to the front of the cabinet.
• Turn the water on to flush debris from line. Run about
• Locate and bring tubing to the front of the cabinet.
• Turn the water on to flush debris from line. Run about
a quart of water through tubing into a bucket; then
shut off water.
shut off water.
If needed cut the tubing to the proper length so it can
be attached to the water valve.
be attached to the water valve.
Copper Tubing:
• Slip a 1/4" nut and ferrule over both ends
• Slip a 1/4" nut and ferrule over both ends
of the copper tubing. Insert tube into the union fitting
on the unit and tighten nut to union.
on the unit and tighten nut to union.
• Turn on the water to check for leaks.
GE SmartConnect™ Tubing:
• Insert the end of the tubing into the refrigerator
• Insert the end of the tubing into the refrigerator
connection. Tighten the compression nut until it is just
hand-tight.
hand-tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
Water
Line Hole
Slot