Samsung RH25H5611BC Manuel Du Propriétaire
English - 10
When moving your refrigerator
To prevent floor damage, be sure the front leveling
legs are in the up position (above the floor).
See “Leveling the Refrigerator” on page 14 for
instructions.
legs are in the up position (above the floor).
See “Leveling the Refrigerator” on page 14 for
instructions.
SCREW DRIVER(-)
CONTROL LEVER
Flooring
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring during
installation, cut a large section of the cardboard
carton and place it under the refrigerator where
you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back.
Do not wiggle it from side to side.
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring during
installation, cut a large section of the cardboard
carton and place it under the refrigerator where
you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back.
Do not wiggle it from side to side.
CAUTION
When installing, servicing, or cleaning behind the
refrigerator, be sure to pull the unit straight out and
push it back in straight after finishing.
refrigerator, be sure to pull the unit straight out and
push it back in straight after finishing.
Important: Make sure that you can easily move
your refrigerator to its final location by measuring
doorways (both width and height), thresholds,
ceilings, stairways, etc.
your refrigerator to its final location by measuring
doorways (both width and height), thresholds,
ceilings, stairways, etc.
• Make sure you disconnect the water supply line
BEFORE removing the freezer door.
To avoid damage, refer to ‘Separating the water
line from the refrigerator’ on page 12.
To avoid damage, refer to ‘Separating the water
line from the refrigerator’ on page 12.
SETTING UP THE REFRIGERATOR
Installing the handles
Important : If you need to remove the refrigerator’s
doors to move it into place, install the handles after
you put the doors back on.
To remove the doors, see “Removing the
Refrigerator Doors” on page 11.
Take the handles out of the right side door.
doors to move it into place, install the handles after
you put the doors back on.
To remove the doors, see “Removing the
Refrigerator Doors” on page 11.
Take the handles out of the right side door.
(Only RH25* models)
Unpack the handles and locate the door
installation packet with the fixer screws
and hex wrench.
installation packet with the fixer screws
and hex wrench.
DA68-02981J-00.indb 10
14. 11. 6. �� 2:04