Dacor DCT305SLP Manuel De Montage
8
Installation Instructions
SimmerSear™ Burner Assembly
(center of cooktop)
Standard Burner Assembly
Left Rear Standard Burner Assembly - DCT305
Igniter
Igniter
Burner cap
(bottom shown)
Burner cap
(bottom shown)
Inner burner cap
(bottom shown)
Outer burner cap
Burner ring
Burner ring
Burner ring
Burner base
Burner base
Burner base
Line up
indentations on
bottom of burner
ring with pins on
top of base.
Installing the Burner Components
WARNING
• Never attempt to operate the cooktop with any of the
burner parts removed.
• Do not attempt to adjust the burner air mixture set-
tings. All adjustments are preset at the factory.
1. Remove the burner rings, burner caps and grates from
their shipping packages.
2. Assemble the burners as shown. Match the burner
parts to the correct size and type of burner. When
installing the burner components, make sure they are
centered. Twist each piece back and forth slightly until
it drops completely into place. The burners will not
operate properly unless all of the burner pieces are
properly seated. On model DCT305, the left rear burner
cap has tabs on the bottom that fit into the slots on the
top of the burner ring.
Fit hole in burner
ring over igniter
Fit hole in burner
ring over igniter
CAUTION: Top of
igniter is sharp
CAUTION: Top of
igniter is sharp