Maytag W10315283RP Manuel De Montage

Using a Torx

®†

 T25 screwdriver, remove the 2 screws securing 

the door strike to the door frame of the dryer. Remove the 4 

screws above and below the door strike and set aside for later 

use. Rotate the strike 180° and attach to the opposite side of 

dryer door frame, as shown. 

Position the door with the inside of the door facing up.  

Using a Phillips screwdriver, remove the 17 screws securing 

the inner door to the outer door. Lift off the inner door and  

set aside. 

NOTE: There is a small release tab on each side of the door.  

If the inner and outer door do not separate easily, slide a  

credit card, putty knife, or similar flat object between the inner  

and outer doors at the locations shown to release the tab.

Using a Phillips screwdriver, remove the 4 screws attaching 

the outer door trim to the outer door liner/window assembly 

and remove trim.

Using a Phillips screwdriver, remove the 2 screws attaching 

the outer window and door handle to the outer door liner and 

remove.

Release tab

Release tab