Amana REK10B Manuel De Montage

This kit provides ten attractive replacement escutcheons,
allowing the removal of control knobs and graphics no longer
required when a wall thermostat is used to control the unit.
The kit also includes 80 jumper wires and wire nuts to provide
connection from the 14-pin terminal strips on the PTAC
control boards to the manufacturer-approved remote thermo-
stats and one of the following board features:

Emergency Hydronic Heat*

Load Shedding*

Front Desk Control*

Transfer Fan (relay must be manufacturer-approved
and have a DC low voltage coil)

IO-649A
March 2007

As a professional installer you have an obligation to know the

product better than the customer.  This includes all safety precautions

and related items.

Prior to actual installation, thoroughly familiarize yourself with this

Instruction Manual. Pay special attention to all safety warnings.

Often during installation or repair it is possible to place yourself in

a position which is more hazardous than when the unit is in

operation.

Standard Touch Pad

Standard Knob Pad

Remember, it is your responsibility to install the product safely and to

know it well enough to be able to instruct a customer in its safe use.

Safety is a matter of common sense...a matter of thinking before acting.

Most dealers have a list of specific good safety practices...follow them.

The precautions listed in this Installation Manual are intended as

supplemental to existing practices.   However, if there is a direct conflict

between existing practices and the content of this manual, the

precautions listed here take precedence.

(2) Knob Escutcheon

Remote Escutcheon

THIS UNIT IS CONTROLLED BY

WALL MOUNTED THERMOSTAT