GE JRP20SKSS Utilisation Et Entretien
24
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Before you call for service…
Troubleshooting Tips
Problem
Possible Causes
What To Do
“F— and a number
You have a function
• Touch the CLEAR/OFF pad. Allow the oven to cool for
or letter” flash
error code.
one hour. Put the oven back into operation.
in the display
If the function
• Disconnect all power to the oven for at least 30
code repeats.
seconds and then reconnect power. If the function
error code repeats, call for service.
error code repeats, call for service.
Display goes blank
A fuse in your home may
• Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
breaker tripped.
The clock is in the
• See the Special features of your oven control section.
black-out mode.
Display flashes
Power failure.
• Reset the clock.
Unable to get the
Oven control pads were
• The BAKE and BROIL HI/LO pads must be touched
display to show “SF”
not pressed properly.
at the same time and held for 3 seconds.
Power outage,
Power outage or surge.
• Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
and resetting any cooking function.
“Burning” or “oily”
This is normal in a
• To speed the process, set a self-clean cycle for a
odor emitting from
new oven and will
minimum of 3 hours. See the Using the self-cleaning
the vent
disappear in time.
oven section.
Strong odor
An odor from the insulation
• This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
oven is normal for the first
few times the oven is used.
Fan noise
A cooling fan may
• This is normal. The cooling fan will turn on to cool
automatically turn on.
internal parts. It may run for up to 2 hours after the
oven is turned off.
oven is turned off.