GE JGRP20SENSS Manuel De Montage

Use a screwdriver to loosen the air shutter
screw.

1. If the flames were yellow, open the air

shutter more than the original setting.

2. If the flames blew away or fluttered from

the burner, close the air shutter more than
the original setting.

Make the adjustment.

Retighten the air shutter screw.

Close the door and recheck the flame.

1. Replace the orifice fitting cover.

2. Replace the oven baffle (flame spreader).

3. Replace the oven bottom.

The broil burner is located and accessible in
the top rear of the oven.

Use a screwdriver to loosen the air shutter
adjustment screw.

1. If the flames were yellow, open the air

shutter more than the original setting.

2. If the flames blew away or fluttered from

the burner, close the air shutter more than
the original setting.

Make the adjustment.

Retighten the air shutter screw.

Close the oven door and recheck the flame.

Open the oven door.

Remove the oven bottom.

Remove 4 screws to remove baffle (flame
spreader).

Remove orifice fitting cover.

The oven is factory-adjusted for use with Natural
Gas in most areas. But, since the gas in some
areas may vary, you should check all adjustments
described below. If you are to use L.P. Gas, see
L.P. Adjustments at the back of this guide.

NOTE: Bake and broil flame must be checked 
with the door closed to properly check flame
characteristics. To properly check the bake burner,
the oven bottom and oven baffle must be removed.

Turn on the bake or broil burner.

As you watch the flame with the oven door
closed, check the following through the oven
door window:

1. Burner flames should not flutter or blow

away from the burner.

2. They should be blue in color with no trace

of yellow.

3. The inner cone of the flame should be

approximately 1/2

″ to 3/4″ long.

Orifice
Fitting
Cover

Air Shutter

Air Shutter

Screw

Oven Bottom

Burner Baffle