Summit CM406W Utilisation Et Entretien
3
INSTALLATION INSTRUCTIONS
Before Using Your Refrigerator
• Remove the exterior and interior packing.
•
•
CAUTION:
After unpacking you MUST allow this appliance to stand upright for at least 2
hours to allow the lubricant and refrigerant to drain back into the compressor and
stabilize. Failure to do so may adversely affect performance and the lifetime of this unit
stabilize. Failure to do so may adversely affect performance and the lifetime of this unit
.
• Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Refrigerator
• This appliance is designed to be free standing only, and should not be recessed or built-in.
• Place your refrigerator on a floor that is strong enough to support the refrigerator when it is
• Place your refrigerator on a floor that is strong enough to support the refrigerator when it is
fully loaded. To level your refrigerator, adjust the leveling leg at the bottom of the refrigerator.
• Allow about 5” (12 cm) of space at the back and sides of the refrigerator, which allows the
proper air circulation to cool the compressor.
• Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extremely cold ambient temperatures may also cause the refrigerator not to
perform properly.
consumption. Extremely cold ambient temperatures may also cause the refrigerator not to
perform properly.
• Avoid locating the refrigerator in moist areas.
• Plug the refrigerator into an exclusive, properly installed and grounded wall outlet. Do not
• Plug the refrigerator into an exclusive, properly installed and grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized service center.
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours
before placing food in the refrigerator compartment.
Electrical Connection
•
This refrigerator should be properly grounded for your safety. The power cord of this
refrigerator is equipped with a three-pin plug which mates with standard three prong wall
outlets to minimize the possibility of electrical shock.
refrigerator is equipped with a three-pin plug which mates with standard three prong wall
outlets to minimize the possibility of electrical shock.
•
Do not under any circumstances cut or remove the third ground prong from the power cord
supplied.
supplied.
•
This refrigerator requires a standard 115Volts AC~ 60Hz electrical outlet with three-prong
grounded receptacle.
grounded receptacle.
•
To prevent accidental injury, the cord should be secured behind the refrigerator and not left
exposed or dangling .
exposed or dangling .
•
Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull
straight out from the receptacle.
straight out from the receptacle.
•
Do not use an extension cord with this appliance. If the power cord is too short, have a
qualified electrician or service technician install an outlet near the appliance.
qualified electrician or service technician install an outlet near the appliance.
Warning
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by an authorized service center.
cord is damaged, have it replaced by an authorized service center.