Summit GC22SS Manuel Du Propriétaire
14
IMPORTANT:
always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
Periodically wash the hot plate, the enamelled stell
pan support, the enamelled burner caps “A”, “B”
and “C” and the burner heads "T" (see fig. 10 and
11) with lukewarm soapy water. They should also
be cleaned plugs "AC" and flame detection "TC"
(see fig. 10). Clean them gently with a small nylon
brush as shown (see fig. 12) and allow to dry fully.
Do not wash in the dishwasher. It is very important
to clean the surface soon after every use,when the
glass is still tepid.
Do not allow vinegar, coffee, milk, salted water,
lemon or tomato juice from remaining in contact
with the enamelled surfaces for long periods of
time.
Do not clean using abrasive metal scourers,
powder abrasives or corrosive sprays.
pan support, the enamelled burner caps “A”, “B”
and “C” and the burner heads "T" (see fig. 10 and
11) with lukewarm soapy water. They should also
be cleaned plugs "AC" and flame detection "TC"
(see fig. 10). Clean them gently with a small nylon
brush as shown (see fig. 12) and allow to dry fully.
Do not wash in the dishwasher. It is very important
to clean the surface soon after every use,when the
glass is still tepid.
Do not allow vinegar, coffee, milk, salted water,
lemon or tomato juice from remaining in contact
with the enamelled surfaces for long periods of
time.
Do not clean using abrasive metal scourers,
powder abrasives or corrosive sprays.
WARNINGS:
comply with the following instructions, before
remounting the parts:
- check that burner head slots have not
comply with the following instructions, before
remounting the parts:
- check that burner head slots have not
become clogged by foreign bodies.
- Check that enamelled burner cap “A-B-C”
(fig. 10-11) have correctly positioned on the
burner head. It must be steady.
burner head. It must be steady.
- The exact position of the pan support is
established by the rounded corners, which
should be set towards the side edge of the
hot plate.
should be set towards the side edge of the
hot plate.
- Do not force the taps if they are difficult open
or close. Contact the technical assistance
service for repairs.
service for repairs.
- Correctly preserve the plate after use by
treating it with special products, easily
available on the market. This will keep the
surface of the plate clean and bright. The
operation will also prevent the formation of
rust.
available on the market. This will keep the
surface of the plate clean and bright. The
operation will also prevent the formation of
rust.
- Don’ t use steam jets for the equipment
cleaning.
- Burned food on an electric plate must be
removed dry.
- After use, pour a little lukewarm oil on the
plate and wipe it with a cloth.
CLEANING
FIG. 12
FIG. 11
FIG. 10
Note: continuous use could cause the
burners to change colour due to the high
temperature.
burners to change colour due to the high
temperature.