Summit SCR486L Manuel Du Propriétaire

LOCATION OF PARTS

Handle

Half Shelf (Total 1)

Door

Digital Control Panel

Levelling Legs

Security Lock

Interior Light

Full Shelf (Total 3)

INSTALLATION INSTRUCTIONS

• Remove the exterior and interior packing.

BEFORE USING YOUR APPLIANCE

•

CAUTION: After unpacking and b

efore connecting the appliance to the power source,

you MUST

allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to
drain back into the compressor and stabilize. Failure to do so may adversely affect performance
and the lifetime of this unit.

• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door. (See page 7.)

• The appliance is designed for free-standing installation only.

INSTALLATION OF YOUR APPLIANCE

• WARNING: Do not store or install the appliance outdoors.
• CAUTION

This appliance is designed for storing and cooling beverages and drinks. Do not store

perishable food, medicine or other medical products.

• Place your Beverage Merchandiser on a floor that is strong enough to support it when it is fully loaded.

To level the unit, adjust the front leveling legs.

• For free-standing installation, leave 5 inches (127mm) of space around the back and sides of the unit

to allow proper air circulation to cool the compressor and condenser.

• NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating

source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.

• Avoid locating the unit in moist areas.