Whirlpool WEE760H0DH Manuel De Montage

4. Drill two 

¹⁄₈" (3 mm) holes that correspond to the bracket 

holes of the determined mounting method. See the following 
illustrations.

5. Using the Phillips screwdriver, mount anti-tip bracket to the 

wall or floor with the two #10 x 1

⁵⁄₈" (4.1 cm) screws provided.

6. Move range close enough to opening to allow for final 

electrical connections. Remove shipping base, cardboard or 
hardboard from under range.

7. Move range into its final location, making sure rear leveling 

leg slides into anti-tip bracket.

8. Move range forward onto shipping base, cardboard or 

hardboard to continue installing the range using the following 
installation instructions.

1. If range height adjustment is necessary, use a wrench or 

pliers to loosen the 4 leveling legs.

This may be done with the range on its back or with the range 
supported on 2 legs after the range has been placed back to 
a standing position.

NOTE: To place range back up into a standing position, put a 
sheet of cardboard or hardboard in front of range. Using 2 or 
more people, stand range back up onto the cardboard or 
hardboard.

2. Measure the distance from the top of the counter to the floor. 

3. Measure the distance from the top of the cooktop to the 

bottom of the leveling legs. This distance should be the 
same. If it is not, adjust the leveling legs to the correct height. 
The leveling legs can be loosened to add up to a maximum of 
1" (2.5 cm). A minimum of 

³⁄₁₆" (5 mm) is needed to engage 

the anti-tip bracket.

NOTE: If height adjustment is made when range is standing, 
tilt the range back to adjust the front legs, then tilt forward to 
adjust the rear legs.

4. When the range is at the correct height, check that there is 

adequate clearance under the range for the anti-tip bracket. 
Before sliding range into its final location, check that the anti-
tip bracket will slide under the range and onto the rear 
leveling leg prior to anti-tip bracket installation.

NOTE: If a Trim Kit will be used, the top of the cooktop 
should be higher than the counter. See the Installation 
Instructions included with the Trim Kit for the correct height.