Maytag MEDC215EW-WW Manuel D’Utilisation

 Level

Caulking gun and 

compound (for installing 

new exhaust vent)

Parts package is located in dryer drum. Check that all parts  

are included.

Check local codes. Check existing electrical supply and venting, 

and read “Electrical Requirements” and “Venting Requirements” 

before purchasing parts.

Mobile home installations require metal exhaust system hardware, 

available for purchase from the dealer from whom you purchased 

your dryer. For further information, please reference the 

“Assistance or Service” section of the “Use and Care Guide”.

If using a power supply cord:
Use a UL listed power supply cord kit marked for use with 

clothes dryers. The kit should contain:

 

■

A UL listed 30-amp power supply cord, rated 120/240 volt 

minimum. The cord should be type SRD or SRDT and be  

at least 4 ft. (1.22 m) long. The wires that connect to the  

dryer must end in ring terminals or spade terminals with 

upturned ends.

 

■

A UL listed strain relief.

Leveling legs (4)

Gather the required tools and parts before starting installation. 

Read and follow the instructions provided with any tools listed here.

Flat-blade screwdriver

#2 Phillips screwdriver

Wire stripper  

(direct wire installations)

Tin snips  

(new vent installations)

Adjustable wrench that 

opens to 1" (25 mm)  or 

hex-head socket wrench 

Vent clamps

1/4" nut driver 

(recommended)

Utility knife 

Tape measure

Pliers