Samsung RH29H9000SR/AA Utilisation Et Entretien
English - 12
When moving your refrigerator
To prevent floor damage, be sure the front levelling
legs are in the up position (above the floor).
Refer to ‘Levelling the refrigerator’ in this manual
(page 16).
legs are in the up position (above the floor).
Refer to ‘Levelling the refrigerator’ in this manual
(page 16).
Screw Driver
Leg
Flooring
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back.
Do not wiggle it from side to side.
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back.
Do not wiggle it from side to side.
Required Tools (Not provided)
Philips
screwdriver (+)
Flat-blade screw
driver (-)
Socket wrench
(13/32”) (10 mm)
Allen wrench
(3/16”) (5 mm)
REMOVING THE REFRIGERATOR
DOORS
DOORS
If your entrance won’t allow the refrigerator to pass
easily through it, you can remove the doors.
easily through it, you can remove the doors.
To remove the doors, follow the steps below.
If you do not need to remove the doors, go to
“Leveling the Refrigerator” on page 16.
If you do not need to remove the doors, go to
“Leveling the Refrigerator” on page 16.
1. SEPARATE THE WATER SUPPLY LINES
FROM THE FRIDGE
FROM THE FRIDGE
1. Pull the two water lines (which are in the Fixer)
out to the front.
DA68-02976A-02.indb 12
14. 4. 23. �� 8:52