Whirlpool WEG760H0DH Manuel De Montage

3. Remove plastic cover from gas pressure regulator cap.

4. Turn gas pressure regulator cap counterclockwise with a 

⁵⁄₈" 

(1.6 cm) combination wrench to remove.

NOTE: Do not remove the spring beneath the cap.

5. Turn over the gas pressure regulator cap and reinstall on 

regulator so that the hollow end faces out and the marking
“



LP” is facing the direction shown in the above drawing.

6. Replace plastic cover over gas pressure regulator cap.

1. Remove burner cap. 

2. Remove the burner base. 

3. Apply masking tape to the end of a 7 mm (

⁹⁄₃₂") nut driver to 

help hold the gas orifice spud in the nut driver while changing 
it. Press nut driver down onto the gas orifice spud and 
remove by turning it counterclockwise and lifting out. Set gas 
orifice spud aside. 

4. Remove the orifice spuds shipped in the literature package in 

the oven. Gas orifice spuds are stamped with a number, 
marked with 1 color dot, and have a groove in the hex area. 
Replace the Natural gas orifice spud with the correct LP gas 
orifice spud.

Refer to the following chart for correct LP gas orifice spud 
placement.

NOTE: Refer to the Model Number and Serial Number Plate 
located on the oven frame behind the top right side of the oven 
door for proper sizing of spuds for each burner location.

5. Place Natural gas orifice spuds in the orifice spud bag.

IMPORTANT: Keep the Natural gas orifice spuds in case of 
reinstallation with Natural gas.

6. Replace the burner base.

7. Replace burner cap.

8. Repeat steps 1-7 for the remaining burners.

A

B

C

D

E

NG

LP

NG

LP

D

A

B

C

14,000 BTU

8,000 BTU

5,000 BTU

1,200 BTU

Silver

Red/Orange

Red/Blue

Black/Orange

1.05

0.85

0.65

0.32

L105

L85

L65

L32

A

B

C

D

A