CellarPro Wine Cellar Mini-Split Refrigeration System Manuel De Montage

* * I M P O R T A N T * *

I N S T A L L E R S M U S T F I L L O U T T H I S S H E E T A N D

F A X T O

7 0 7 . 7 9 4 . 8 0 0 5 O R S C A N / E M A I L T O I N F O @ C E L L A R P R O . C O M

T O A C T I V A T E T H E W A R R A N T Y .

Installing CellarPro Split Systems requires an experienced professional and adherence to industry practices which
are described in the manual. To activate the warranty, the cooling unit must be installed properly. In order for us to
assess and approve the installation, the installing technician must complete the page below. The page can be faxed
to 707.794.8005 or emailed to info@cellarpro.com. We will contact you once we receive and review this sheet.

Technician Information

Name

Phone

System Information

Piping Information

Customer Name

R-134a system charge lb.

Condensing Unit Model #

Line-set length – ft.

Condensing Unit Serial #

Liquid line diameter – OD

Evaporator Model #

Suction line diameter

Evaporator Serial #

Operational Data

Take the following measurements during a normal refrigeration cycle, once the cellar has pulled down to
the set-point temperature. Make sure the compressor is running when recording the data

Evaporator

Comment

Air temperature at Evaporator coil inlet/outlet

°F/°F

8-10°F TD

Evaporator fan speed (High / Med / Low)

Evaporator power supply voltage & amps

V & A

103-127 V – check

nameplate amps

Condensing Unit

Air temperature at Condenser coil inlet & outlet

°F/°F

20-30°F TD

Condenser fan status (ON / OFF)

Suction pressure at suction service valve

PSIG

25-35 PSIG

Suction temperature at suction service valve

°F

20°F Superheat Min.

Liquid pressure at liquid service valve

PSIG

105-180 PSIG

Liquid temperature at liquid service valve

°F

10-20°F Subcooling

Condensing Unit power supply voltage & amps

V & A

103-127 V – check

nameplate amps