Summit 30" Wide Built-In Undercounter Wine and Beverage Center Stainless Steel French Doors Manuel Du Produit

Page de 32
 
National Electrical Code and local codes and ordinances, is 
required. 
•  Do not kink or pinch the power supply cord of the appliance. 
•  The fuse (or circuit breaker) size should be 15 amps. 
•  It is important for the appliance to be leveled in order to work 
properly. You may need to make several adjustments to level it. 
•  Although the unit has been tested at the factory, due to transit and 
storage, you should clean the appliance before use. 
•  Do not use solvent-based cleaning agents or abrasives on the 
interior. These cleaners may damage or discolor the interior. 
•  Do not use this apparatus for other than residential purposes. 
•  This appliance is CFC- and HFC-free and contains small quantities 
of Isobutane (R600a) which is environmentally friendly, but 
flammable. It does not damage the ozone layer, nor does it 
increase the greenhouse effect. Care must be taken during 
transportation and setting up of the appliance that no parts of the 
cooling system are damaged. Leaking coolant can ignite and may 
damage the eyes.   
In the event of any damage: 
-  Avoid open flames and anything that creates a spark, 
-  Disconnect from the electrical power line, 
-  Air the room in which the appliance is  located for several 
minutes, and 
-  Contact the Service Department for advice. 
•  The more coolant there is in an  appliance, the larger the room it 
should be installed in. In the event of a leakage, if the appliance is 
in a small room, there is the danger of combustible gases building 
up.  For every ounce of coolant at least 325 cubic  feet  of  room 
space is required. The amount of coolant in the appliance is stated 
on the data plate on the back of the appliance. It is hazardous for 
anyone other than an Authorized Service Person to carry out 
servicing or repairs to this appliance.   
•  Take serious care when handling, moving, and using the appliance 
to avoid either damaging the refrigerant tubing  or increasing the 
risk of a leak. 
•  Replacing component parts and servicing shall be done by 
factory-authorized service personnel so as to minimize the risk of 
possible ignition due to incorrect parts or improper service.