Orien FSR-24OD Outdoor Stainless Steel Refrigerator Manuel Du Produit

Page de 25
 
 
Operating Your Refrigerator 
 
IMPORTANT: Do not plug in the unit for at least 24 hours after unit is set in place. 
Failure to do so may result in the unit working improperly. 
 
This  refrigerator/beverage  cooler  has  a  rotary  temperature  control  knob 
(thermostat) marked with the settings COLD23456COLDEST in order of 
increasing coldness. In addition, this model employs a heater inside the cabinet, 
and is designed for outdoor use.    When the temperature is colder than the tem- 
perature setting, the heater works automatically to maintain the temperature setting. 
 
Note: To prevent excessive strain on the compressor, do not leave the 
unit at the COLDEST setting for more than an hour at a time. 
 
OPERATING INSTRUCTIONS 
 
Turning on the Unit 
The refrigerator turns on automatically when it is plugged in. 
 
Note: If you unplug the refrigerator or the power is cut off accidentally, 
allow 8 minutes before restarting it or plugging it back in. It will not 
operate properly in less than 8 minutes.   
 
Temperature Setting 
Initially set the thermostat to setting 4. The compressor will run continuously for a 
few hours and only after the temperature inside the appliance becomes stable will 
the compressor run normally (i.e., turn on and off periodically). 
 
When the unit is operated for the first time, it is suggested that you not put foods in 
until the compressor is running normally. 
 
Adjusting  the  thermostat  counter-clockwise  will  make  the  compressor  run  for  a 
longer time with a shorter compressor stop time, and the temperature inside the 
appliance  will  be  colder.  The  setting  should  be  regulated  according  to  ambient 
conditions and the desired temperature. The compressor will run for a while after 
each regulation before reaching a steady temperature.   
 
Please note: 
Cold air falls and warmer air rises, and there will be a small 
temperature  variation  from  the  bottom  of  the  unit  to  the  top.  The 
temperature at the bottom of the unit will always be slightly colder.