Electrolux EIFLS55IIW Manuel Du Propriétaire

Page de 32
20
Operating Instructions
DELAY START
Use delay start with any cycle to select a wash 
time convenient to your schedule or during off 
peak energy hours. The start of the cycle can be 
delayed for up to 14 hours. The delay time select-
ed will be displayed as 30, 60, or 90 minutes or 2 
through 14 hours.
CONTROL LOCK
To lock the controls between cycles, press and 
hold the control lock button for 5 seconds. Re-
peat to unlock the controls when you are ready to 
operate the washer. Use this feature to reduce the 
likelihood of accidental operation by children.
STATUS DISPLAY
The estimated total cycle time will be displayed 
when the cycle is selected. The time may increase 
if water pressure is low, oversudsing occurs or the 
load becomes unbalanced. The approximate time 
remaining will be displayed during the cycle.
A situation where oversudsing has been detected 
by the washer will result in the washer automati-
cally adding up to 4 extra rinses to attempt to clear 
the suds. Each extra rinse the washer performs 
to clear the suds will add 5 minutes to the cycle 
display time. If an excessive amount of detergent 
has been added and additional rinsing has not cor-
rected the issue, 
TOO MUCH DETERGENT
 will be 
displayed.
DRUM LIGHT
The drum light will come on whenever the door is 
opened to illuminate the drum during loading and 
unloading. Closing the door turns off the light. The 
drum light will automatically turn off if the door is 
left open more than 3 minutes.
REVERSIBLE DOOR
Your washer is equipped with a reversible door. 
The door can be hinged on the right or left side.
       NOTE
For step-by-step instructions on DOOR 
REVERSAL, refer to the Installation Instructions 
supplied with this washer.
DOOR LOCK
PREWASHING
WASHING
ADDING STEAM
RINSING
DRAINING
SPINNING
CYCLE COMPLETE
STATUS DISPLAY
The following will also be displayed at the 
appropriate times during the cycle:
SYSTEM CLEAN
To clean and freshen the washer, perform the SYS-
TEM CLEAN
 cycle. If you wish to begin the cycle, 
press select when prompted. This maintenance 
cycle uses hot water and two rinses to remove 
residue that may cause odor. See Inside Routine 
Cleaning (Preventative)
 for detailed information 
about the SYSTEM CLEAN cycle.
       NOTE
The washer will automatically prompt you to 
run the SYSTEM CLEAN cycle every 50 cycles. 
You may press the cancel  button  to  manually                         
perform the cycle at another time.
Washer Features