Electrolux EI24MO45IBEI27MO45TS Manuel Du Propriétaire

Page de 30
E
6
GROUNdING INSTRUCTIONS
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a ground-
ing plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance 
with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, 
grounding reduces risk of electric shock by providing an escape wire for the electric current.
 Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or 
more protected electrical supply. It is recommended that a separate 
circuit serving only this appliance be provided. 
The oven is equipped with a 3-prong grounding plug. It must be plugged 
into a wall receptacle that is properly installed and grounded. Should 
you  only  have  a  2-prong  outlet,  have  a  qualified  electrician  install  a 
correct wall receptacle.
A  3-prong  adapter  may  be  purchased  and  used  temporarily  if  local 
codes allow. Follow package directions.
A  short  power-supply  cord  is  provided  to  reduce  risk  of  becoming 
entangled in or tripping over a longer cord. DO NOT USE AN EXTENSION 
CORD. If the power supply cord is too short, have a qualified electrician 
or serviceperson install an outlet near the appliance.
NOTES:
1.  If you have any questions about the grounding or electrical instruc-
tions, consult a qualified electrician or serviceperson.
2.  Neither Electrolux nor the dealer can accept any liability for damage 
to the oven or personal injury resulting from failure to observe the 
correct electrical connection procedures.
Radio or TV Interference
Should  there  be  any  interference  caused  by  the  microwave  oven  to  your  radio  or  TV,  check  that  the 
microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as 
feasible or check position and signal of receiving antenna.
TINSLB003.indb   6
12/11/08   9:30:33 AM