ADC T1MF2S04RA Manuel D’Utilisation
2-14
Install LPS-300C Procedure
ATTENTION
Use anti-static wrist-straps connected to the ESD Jack (located on the right adapter bracket, see
Figure 1-1 on page 1-2) when inserting a circuit card. Avoid touching components on the
circuit card.
Figure 1-1 on page 1-2) when inserting a circuit card. Avoid touching components on the
circuit card.
Step
Action
1
Hold the LPS-300C Power Module vertically with the front of the circuit card toward you. Align the top and
bottom edges of the LPS-300C with the HMS-318 List 3 shelf slot guides.
bottom edges of the LPS-300C with the HMS-318 List 3 shelf slot guides.
2
Slide the LPS-300C Power Module into its respective slot.
3
Press the LPS-300C Power Module firmly into the connector until it is seated into the edge-connector on
the shelf backplane.
the shelf backplane.
Note:
The LPS-300C will power up with various status LEDs indicating power up status (refer to the
LoopStar LPS-300C L1 Power Module Technical Practice, catalog number SCP-LPS300-010 in the
“Related Publications” on page iii for the proper power up descriptions).
“Related Publications” on page iii for the proper power up descriptions).