Sony PCNA-MR10 Manuel

❑

Connect the AC adapter securely. The standby indicator light is red 
(dimmed) after the AC power cord is connected between the network media 
receiver unit and the wall power outlet.)

❑

Verify that all cables are connected securely.

❑

If you are using a power cord extension, power strip, or surge suppressor, 
make sure that it is turned on and securely connected to the wall power 
outlet.

❑

Verify that the fresh batteries are properly installed in the Remote 
Commander® unit.

❑

Unplug the AC adapter from the power outlet and plug it again. Doing so 
resets RoomLink™ to the original factory default settings. 

❑

If the displayed screen is frozen or unresponsive, or you cannot turn the 
network media receiver off, the unit may have become unstable. 
To reset the unit:

Press the POWER button on the network media receiver for more than 
five seconds or disconnect the AC adapter from the network media 
receiver. 

Wait 20 seconds for the standby indicator to light in red, then turn the 
network media receiver unit on. 

Resetting the network media receiver or reconnecting the AC adapter 
resets the unit’s settings to the original factory default settings. 

❑

To completely disconnect power to the network media receiver, unplug the 
AC adapter.

✍

RoomLink goes into Standby mode and the standby indicator light is red (dimmed).