Sony PCNA-MR10 Manuel
Setting Up RoomLink
29
Attaching the ferrite core
In accordance with FCC Rules, Part 15, a ferrite core is supplied with the
network media receiver. The ferrite core should be attached to the network
cable
network media receiver. The ferrite core should be attached to the network
cable
*
, to reduce or eliminate electrical interference.
1
Open the ferrite core and place the core approximately 3-4 inches from the
end of the network cable.
end of the network cable.
2
Wrap the network cable twice around the ferrite core, lengthwise, with the
cable running directly through the center groove of the core.
cable running directly through the center groove of the core.
3
Close the ferrite core tightly around the network cable until the core locks.
* The network cable must be compatible with the 100BASE-TX standard.
To attach the ferrite core
Ferrite core
Ethernet port